Hey guys I'm In the middle of installing the rockers and I'm wonder the pins that holds the rockers in have a slot in them and I would make sense the the slot meets the oil hole in the rocker but I just wanted to confirm before I put them and and had them backwards any help is appricated
Proud new owner of a norton commando
- Thread starter dlou0338
- Start date
- Status
- Joined
- Nov 20, 2004
- Messages
- 20,415
dlou0338 said:
The rocker spindles must be fitted so the flats on the inlet spindles face to the rear and exhaust to the front, so away from the cylinder head in both cases. Do not fit the spindles so the holes line up with the rocker drillings.
http://www.classicbike.biz/Norton/Repai ... mmando.pdf
Section C8.
I am having a bit of an internal debate about my carbs I don't know weather or not to rebuild the amals I have buy new ones not sure if they've been updated or not or to go with a single mikuni of any one has any advice I would appreciate it thanks in advance
Thanks I'll look for it much appreciated
- Joined
- May 5, 2017
- Messages
- 657
This thread debates which is better, single or dual carbs.
https://www.accessnorton.com/NortonCommando/regarding-single-carb-setups-on-commandos.24800/
This one is on advice for buying a bolt on single or dual Mikuni conversion
https://www.accessnorton.com/NortonCommando/better-carb-in-kit.24794/#post-366793
This one gives advice on improving the performance of a single Mikuni [older]
https://www.accessnorton.com/NortonCommando/better-carb-in-kit.24794/#post-366793
Thanks alot much appreciated
- Status
Similar threads
