Norvil Belt Drive Install Questions

nomadwarmachine · Nov 6, 2019

maylar said:
A small sanding drum or grinding stone in a Dremel will relieve the epoxy around the stator mounts. I had to do that with my e-start install.

That is exactly what I had in mind. Did you sand down the epoxy or the mount?

maylar · Nov 6, 2019

nomadwarmachine said:
That is exactly what I had in mind. Did you sand down the epoxy or the mount?

The epoxy. It's quite soft actually (mine is a Sparx stator). I found a drum that was exactly the right size in my Dremel stuff.

nomadwarmachine · Nov 6, 2019

maylar said:
The epoxy. It's quite soft actually (mine is a Sparx stator). I found a drum that was exactly the right size in my Dremel stuff.

That makes sense. Looks like a fraction of an inch in order to get the stator to slide over the stud casting. Will have a go at it tonight.