Hello Phil , If you have just been to the Norton Factory or Dealer and your EML is still on , I would bring it right back ! If it is a long way away and you will not be going back soon you can try to reset it by disconnecting the battery for several minutes and reconnect and try it again. What year is your bike ?Just had my 961 1st service and engine management light still on, they replaced the temp sensor on the service
Have any other guys had same issues and is it safe to ride
I have decats fitted
Phil, I just had my annual service and they replaced my temp sensor but no eml on mine so I don't think it is related but check the connector anyway.Just had my 961 1st service and engine management light still on, they replaced the temp sensor on the service
Have any other guys had same issues and is it safe to ride
I have decats fitted
Thanks Raphi. I feel better about that. That was the only message could get while it was stuck on one screen. It did go to WARN for about 3 seconds. Pretty sure it was weak battery. All is fine now after a good ride and a charge. I keep it on a charger year round but forgot just for 5 days.ILL # means illumination and the number 0-9 (or 10?) stands for the brightness of the speedo lights. I think you can change by holding button whilst Voltage is shown.
This is definitely no warning message...
Light went off when I started it at factoryDoesn't the EML have to be reset by the factory after completing service?
Was the light out when you got the bike back after service?
2018 modelHello Phil , If you have just been to the Norton Factory or Dealer and your EML is still on , I would bring it right back ! If it is a long way away and you will not be going back soon you can try to reset it by disconnecting the battery for several minutes and reconnect and try it again. What year is your bike ?