Production racer seat

Can anybody tell me how the PR seat is attached to the frame? There seems to be a Druz fastener on the tail fairing - does this then engage in a special frame bracket?
I want to use a PR seat on my track bike, and was just wondering how it's attached.

/Steve in Denmark

there are 2 steel plates at the front , formed in a hook wich locate under the frametubes , on the front that is
at the rear there is a dzus or a bolt

be carefull when you buy one , they all seem to be made out of a mould taken from an existing seat so the 'new' seats sit too high on the frame , instead of sitting round the rear loop
the last one i had came from Mick Hemmings i believe , and that one could only be persueded to fit with a bit of tlc . Most of the seats you see nowadays are sitting at least half an inch above the frame

This might help.



Ken

That is how the factory recommended to do it.

I followed Paul on how he did his. Very slick and won't crack like the factory location.

how-fit-the-seat-production-racer-t7068.html