When you bend the tab it is possible to compress the pivot pin hole causing it to bind. If you press on the tickler too hard I think it is possible to bend the tab, that is the only reason I can come up with that would explain how the level changed in one of my carbs.
Thanks for this idea. I was careful to bend the tab before the tangs. I will check to make sure that the "elbow" I created doing so does not bind on the carb body.
I was actually referring to the two little holes on the float where the float pin goes. When I bent the tab it actually reduced the ID of the holes and was binding on the pin itself.
I was actually referring to the two little holes on the float where the float pin goes. When I bent the tab it actually reduced the ID of the holes and was binding on the pin itself.
The Access Norton Website uses cookies to keep you logged in if you register.
By continuing to use www.accessnorton.com, you are consenting to our use of cookies.
