- Joined
- Feb 21, 2019
- Messages
- 1,067

this should pretty much be a no-brainer, BUT, i must be doing something wrong with my cable routing. i've pulled the end out of the cable where it's crimped over the outer covering 3X now. something's wrong. from the speedometer, i'm running the cable down the front frame member, and horizontal accross the lower frame member, and this is where i'm thinking i'm doing something wrong. fairly sure i have enough slack in the cable to allow for rear swing arm travel. something's going on here. QUESTION - on the bottom horizontal frame member should the cable route on the inner side or outer side of the frame? the part of the gearbox where the cable screws in, should that be positioned horizontally or angled slightly down? pretty sure i'm using the proper length cable - 69 inches. i've had pretty good luck with emgo products, so i just ordered a new emgo cable from the bonniville shop.
Last edited: