How to polish the chromed fork tubes without taking them off the bike ?

DennisMo said:
I am rebuilding my forks and pulled everything out by jacking up my bike and leaving the forks in place.
I would like to polish the fork tubes that are still attached to the bike.
It looks extremely labour intensive as I think I don't want to use 2000 wet/dry paper on it which leaves me only using chrome polish.

Does anyone have any suggestions??

Always grateful and with thanks

Dennis
Vancouver
Click to expand...
Use some 3000 grit and you will find they won't dull , get the high spots of , and have you tried the cheap felt angle grinder discs you can buy great with autosol or compound buy at least two, one for final buff .
 
74ok said:
tried this, worked gd
Click to expand...

Takes the raised rust blisters off, but the pitting in the chrome remains.

A good trick if a seller wants to conceal rust damage.

I filled the pitting with cold galvanize paint on my beater bike. Holding so far.

How to polish the chromed fork tubes without taking them off the bike ?
 
Last edited:
@L.A.B. & @ludwig were right in calling out my post #12 above regarding limited damping on short Roadholders.
I have gone back through old information and what I should have said is there is no hydraulic bump stop for fully extended and compressed conditions.
The paper below (now in Resources) describes this in detail as well as how the Covenant Conversion fixes it plus how to do it.
Cheers
Norton Roadholders - The Hole Story

Atlantic Green (Dynodave) also has a briefer document that covers this.
 
From what I had read online, I had assumed that if there are holes through the lowest extremes of the damper tubes, then blanking them off and redrilling them slightly higher up, provides a small oil reservoir at full compression for damping purposes, n'est-ce pas?,
Or did I read that wrong?
 
Stevo said:
From what I had read online, I had assumed that if there are holes through the lowest extremes of the damper tubes, then blanking them off and redrilling them slightly higher up, provides a small oil reservoir at full compression for damping purposes, n'est-ce pas?,
Or did I read that wrong?
Click to expand...

Where the holes are below the taper in the early damper tubes I can understand but not in the taper of the later dampers.
 
baz said:
The chrome is hard chrome
It's already polished
Click to expand...
I gave mine a tickle up with 3000 grit, it's basically gets the rough bits off , also those cheap felt discs are fantastic , put them on a angle grinder , use with compound or autosol.
 
For round stuff a piece of old tee shirt or soft rag long skinny piece give it a full wrap and see saw it back and forth with autosol doesn’t take long and polishes evenly personally I like to do that stuff by hand
 

Similar threads

S
  • Locked
How to Polish up my Norton?
Replies
7
Views
614
Diablouph
D
Back
Top