Circlip I got at the hardware store was a bit too large, so I'll get the next smaller size.
Drilled the rivets and removed the original VIN plate. Filled the holes with screws, made a blanking plate setup for the steering bearings and ran some pieces of old buffer stud into the threaded holes, so the frame is ready for paint removal.
I think I got the picture problem cured, so I'll go back and post some relevant shots.
Drilled the rivets and removed the original VIN plate. Filled the holes with screws, made a blanking plate setup for the steering bearings and ran some pieces of old buffer stud into the threaded holes, so the frame is ready for paint removal.
I think I got the picture problem cured, so I'll go back and post some relevant shots.