worntorn
VIP MEMBER
- Joined
- Dec 22, 2006
- Messages
- 7,979
Here's a bit of work I did earlier to accomodate the rear wheel and hollow axle.The rear wheel is actually a front wheel for a GSXR600, so more work remains.( Figure out sprocket and brake)
The hollow axle is too large in diameter for the Commando swing arm as is. It needed a piece added, then milling out.
The milling allowed for correction of the slots so that the swing arm pivot and axle are in the same plane.
Glen
This is a cut down GSXR 600 axle with a solid end added. The solid end is a couple of heavy washers and lots of Tig weld, all machined down
The hollow axle is too large in diameter for the Commando swing arm as is. It needed a piece added, then milling out.
The milling allowed for correction of the slots so that the swing arm pivot and axle are in the same plane.
Glen
This is a cut down GSXR 600 axle with a solid end added. The solid end is a couple of heavy washers and lots of Tig weld, all machined down
Last edited: