Reply to thread

not sure the exact name but first I used a self clamping clamp. Angled needle nose squeezing and once in place let go. But it only worked for a month or so then back fired (actual bike backfired) and blew off. At first I wasn’t sure what happened but if I kept it running I could hear the air sucking in. but with the throttle body off I was able to use a small stainless hose clamp with a bolt to tighten. Only thing was its a nightmare to tighten because its soo deep in there to get over the lump on the spigot so that shit silicone hose wont slip off. Took many attempts. the right thing to do is use a rubber hose and push it on with angled hose nose pliers.  Those Silicone hoses are too slippery for the fitting it goes onto. Especially with oil residue in there.