Rocker oil line routing

Status
Not open for further replies.
A styling exercise. Only.
Only you can decide if the fashion is for you.
 
It would be annoying to have that line in the way every time you want to adjust the valves.
 
I've never seen one routed up from the front like that. Normally the only Q is between the manifolds or on the timing side.
 
olympus said:
Hi all
In the process of finalising the routing of the rocker oil feed lines. oil gauge etc. and i found this photo in the media section...
I'd be interested to know the views on this routing??
Click to expand...

I would say the hose was too long and this was a creative fix;)


Regards

Esme
 
concours said:
A styling exercise. Only.
Only you can decide if the fashion is for you.
Click to expand...

Style or fashion had zero to do with the configuration applied. Zero.

batrider said:
It would be annoying to have that line in the way every time you want to adjust the valves.
Click to expand...

The lines are routed the way they are to clear the valve openings.
No annoyance involved.


Look again at where the oil line routing guides are mounted. Above and away from the cover. When the valve cover is removed the braided line lifts up and away offering clear and unimpeded access to the valves for adjustment.

As well, the line guides offer a smooth routing throughout the "run".
No kinks, vibration is suppressed as the oil line vibrates with the engine, not independently of the engine.

And no flopping around or wagging in the wind thus eliminating any friction from rubbing or slapping against any other component.
Functional and user friendly.


Rocker oil line routing


Rocker oil line routing
 
Last edited:
Option #3, eliminate the crossover completely-have your inlet rocker spindles drilled through and run a single line to the right hand head then run a single line off the left hand side to a gauge. I'd post a picture but I'm nowhere near a camera or the bike right now.
 
Last edited:
I am looking for a built up one piece stainless steel braided line that uses a right side "L" fitting( as the original plastic line) ,instead of the easy way that uses a long bolt and three seals and two lines
 
One of my thoughts lying here recovering from an operation is to run two oil lines up from the timing case union... one to the right & one to the left.
 
jimbo said:
I am looking for a built up one piece stainless steel braided line that uses a right side "L" fitting( as the original plastic line) ,instead of the easy way that uses a long bolt and three seals and two lines
Click to expand...

Hard to see, but I'm running that type, I believe I sourced it from BritCycle

Rocker oil line routing
 
Status
Not open for further replies.

Similar threads

jms
Atlas OEM High Pressure Rocker Oil Line
Replies
8
Views
253
kernel65
kernel65
jms
Atlas Rocker Oil Feed Line
Replies
3
Views
172
Matchless
Matchless
Anvill
  • Locked
MKIII standard oil line routing from filter to tank
Replies
5
Views
1,457
Anvill
Anvill
andyd
  • Locked
Early Commando and Atlas rocker line routing
Replies
4
Views
828
Bodger
B
lazyeye6
  • Locked
Rocker oil line protection
Replies
19
Views
3,210
Lineslinger
Lineslinger
Back
Top