Parts for NorCom

excovkid · Dec 14, 2008

I am about to start some looking for parts, for my Norton Comando, looked up Waldrige and British Cycle Supply in Canada, their sites seem to be a bit to teckno for info all pdf, I have dial up, I did phone BCS, they are shipping a parts cat, but dont have a factory shop manual, its a must? . I can get a Haynes but dont like them any ideas? tks

norbsa48503 · Dec 14, 2008

Having the right #'s is power. By not having them you cut your suppliers down to about one third with a lot more room for mistakes. And even those guys like the #'s. So yes a must.

L.A.B. · Dec 14, 2008

I strongly recommend that you get a copy of either the factory or Clymer manual, or both? The Haynes Commando manual isn't that bad either.

There are a couple of factory manuals on the web:

Pdf : http://www.classicbike.biz/Norton/Repai ... mmando.pdf

Or this one (Contents page): http://rocbo.lautre.net/technique/norto ... p/004.html

-where you can select the required section and then use: "<" ">" - to turn the pages.

dezwartj · Dec 14, 2008

You can use the 1-800 # from Walridge (or E-mail them) to request a hardcopy of their parts manual. They will gladly send it to you.

Cheers,

grandpaul · Dec 14, 2008

www.oldbritts.com has all the parts books on-line.

BrianK · Dec 14, 2008

Here too:

http://www.nortonmotors.de/ANIL/Norton% ... s-list.php

Parts for NorCom

excovkid

norbsa48503

L.A.B.

Moderator

dezwartj

grandpaul

BrianK