Reply to thread

Message

I always go the manual way with the first front bolt to pull the head down to position then as said by Marshg said use a fash light to see if the push rods are sitting in position usually one well be off and a small screw driver well easily put it in position, I have never done it with a bit of grease to hold in position as I have never had any problems with them getting out of position but a good idea anyway, once in position tighten the first bolt down as well putting the 4 big bolt screw down and checking the push rods as you go, do it by the book always work for me.

[QUOTE="ashman, post: 618266, member: 2326"] I always go the manual way with the first front bolt to pull the head down to position then as said by Marshg said use a fash light to see if the push rods are sitting in position usually one well be off and a small screw driver well easily put it in position, I have never done it with a bit of grease to hold in position as I have never had any problems with them getting out of position but a good idea anyway, once in position tighten the first bolt down as well putting the 4 big bolt screw down and checking the push rods as you go, do it by the book always work for me. [/QUOTE]

Verification