New posts

Reply to thread

Message

It's a 2015 model Tony. I have two schematics but neither is exactly the same as the harness in the bike. I have been digging around in the throttle position sensor wiring hooking in the Power Commander and feel I may have caused a fault here as the side stand cut out and the TPS both feed into the solid state tilt switch unit. Please note, this is not the actual cut out switch which has three wires and still works - insofar as the engine starts and runs and will cut out when the three-wire switch is tipped on its side. The little black box directly below the actual tilt switch (confusingly) has a sticker on it that says 'tilt switch' and has 8 black wires going into it. I am thinking the problem lies there. When the 8 wire plug is pulled, the bike won't start. I have also disconnected the PC and reverted everything back to original. The bike still starts and runs but cuts out with moving into gear - which it wasn't doing before I fitted the PC.

<blockquote data-quote="DBT" data-source="post: 611011" data-attributes="member: 8908"><p>It&#039;s a 2015 model Tony.&nbsp; I have two schematics but neither is exactly the same as the harness in the bike.&nbsp; I have been digging around in the throttle position sensor wiring hooking in the Power Commander and feel I may have caused a fault here as the side stand cut out and the TPS both feed into the solid state tilt switch unit.&nbsp; Please note, this is not the actual cut out switch which has three wires and still works - insofar as the engine starts and runs and will cut out when the three-wire switch is tipped on its side.&nbsp; The little black box directly below the actual tilt switch (confusingly) has a sticker on it that says &#039;tilt switch&#039; and has 8 black wires going into it.&nbsp; I am thinking the problem lies there.&nbsp; When the 8 wire plug is pulled, the bike won&#039;t start.&nbsp; I have also disconnected the PC and reverted everything back to original.&nbsp; The bike still starts and runs but cuts out with moving into gear - which it wasn&#039;t doing before I fitted the PC.</p></blockquote><p></p>

[QUOTE="DBT, post: 611011, member: 8908"] It's a 2015 model Tony. I have two schematics but neither is exactly the same as the harness in the bike. I have been digging around in the throttle position sensor wiring hooking in the Power Commander and feel I may have caused a fault here as the side stand cut out and the TPS both feed into the solid state tilt switch unit. Please note, this is not the actual cut out switch which has three wires and still works - insofar as the engine starts and runs and will cut out when the three-wire switch is tipped on its side. The little black box directly below the actual tilt switch (confusingly) has a sticker on it that says 'tilt switch' and has 8 black wires going into it. I am thinking the problem lies there. When the 8 wire plug is pulled, the bike won't start. I have also disconnected the PC and reverted everything back to original. The bike still starts and runs but cuts out with moving into gear - which it wasn't doing before I fitted the PC. [/QUOTE]

Verification