Commando Crankshaft Output Shaft Dimensions

R

rotorwrinch

Joined
Dec 12, 2011
Messages
80
Country flag
I always try to compare my measurements with those that are published, especially when it comes to something that is applicable to a Commando. My search to find the dimensions for the output shaft for a pre-MKIII was not fruitful. Yes, one evening this week I will get some numbers off parts here. That , with the help of the Machinist Handbook will likely get me close to shaft size, taper and keyway. It would be good to have something to check my product against. Any have this info in their stash and willing to share it ? Crankshaft Output Shaft Pre MKIII Commando ???
 
rotorwrinch said:
I always try to compare my measurements with those that are published, especially when it comes to something that is applicable to a Commando. My search to find the dimensions for the output shaft for a pre-MKIII was not fruitful. Yes, one evening this week I will get some numbers off parts here. That , with the help of the Machinist Handbook will likely get me close to shaft size, taper and keyway. It would be good to have something to check my product against. Any have this info in their stash and willing to share it ? Crankshaft Output Shaft Pre MKIII Commando ???
Click to expand...
I'm intrigued ....what type of product are you referring to or manufacturing please ?...
 
This info is going into a timed belt engine sprocket project. It has been years since I did the previous incarnation and improvements come with a cost of materials and the time to get them. I am trying to not have to make some of the components twice like I did on the earlier model.
 
Last edited:
Back
Top