- Joined
- Jun 16, 2018
- Messages
- 84
Well ,here we go , My Norvil mock up has had the bar clamps ground off and polished out and it looks ok , problem being my back using clip ons,
so i find a pair of raised clip ons from Dave Degans at Dresda , strip the front end down to fit them only to find they foul the clocks due to the bar "overhang", i would have to turn the clocks in towards each other fully to fit , not a good look, so i see on Barleycorn engineering they have a set of "up swept" clip ons that i may try , has any one found a set of bars that may do the job ? , The bars i bought are no longer listed on Dresda or Chris Knight motorcycles who they were originally ordered through, so i have a set of raised clip ons made from aircraft grade polished stainless going cheap ,
hope to here some good news ,
Cheers Colin
so i find a pair of raised clip ons from Dave Degans at Dresda , strip the front end down to fit them only to find they foul the clocks due to the bar "overhang", i would have to turn the clocks in towards each other fully to fit , not a good look, so i see on Barleycorn engineering they have a set of "up swept" clip ons that i may try , has any one found a set of bars that may do the job ? , The bars i bought are no longer listed on Dresda or Chris Knight motorcycles who they were originally ordered through, so i have a set of raised clip ons made from aircraft grade polished stainless going cheap ,
hope to here some good news ,
Cheers Colin