Reply to thread

Message

Place 2 business cards on each side of the pointer. The cards will be either side of the pointer stop. Get the cards right up on the pointer shaft. With 2 thin flat blade screw drivers, with a quick twist pop the pointer off. The dial face is held on with push rivets. push out the center pins and lift off the dial. After that, it can get tricky. The remainder of the instrument is riveted together. If it were me, I would send it off to Andy in Alberta. Based on what you're describing, you'd be best served that way because there's other things going on. If you were in the US, there's a couple of us that can do the work.

[QUOTE="bmepkid, post: 686180, member: 11696"] Place 2 business cards on each side of the pointer. The cards will be either side of the pointer stop. Get the cards right up on the pointer shaft. With 2 thin flat blade screw drivers, with a quick twist pop the pointer off. The dial face is held on with push rivets. push out the center pins and lift off the dial. After that, it can get tricky. The remainder of the instrument is riveted together. If it were me, I would send it off to Andy in Alberta. Based on what you're describing, you'd be best served that way because there's other things going on. If you were in the US, there's a couple of us that can do the work. [/QUOTE]

Verification