961 MANUALS

Adjusted the valve clearances yesterday. They were good but I captured it so the next manual will be CHECK AND ADJUSTING VALVE CLEARANCES. The Valve Cover is so cool looking. Its too bad most of it is covered by the tank. I polished it anyways.
 
New Manual available. Emailed today if you are on the list. If not there is a low res version available on the CNW website.

VALVE CLEARANCE (Check & Adjust)
 
My apprentice and current state of my garage.
961 MANUALS

961 MANUALS
 
The new Manual I'm working on is called OIL ROUTE. So far its pretty awesome. Thanks to TonyA for asking for it. Hopefully done by the end of the week.
 
Hi Richard I'm a new owner and am interested in all of your updates could you add me to your email list thanks and let me know how I can donate to your account

Thanks Brian
 
Thanks Guys.

Simply PM me your email address and I will add you and send you the complete HIGH RES versions of all the manuals I have so far and any more to come (there are a lot in the works). Or reply to this thread with your email and then delete the post after I email you.

Richard
 
Just an update that I have 17 manuals so far.

1 - Fuel Tank Removal - Norton 961 (Get to battery and main fuse)
2 - Removing Primary Side Cover - Norton 961 (Lots of reasons to get in here)
3 - Removing Clutch Basket - Norton 961 (if you need to get to starter or check ring gear or replace clutch plates)
4 - Cylinder Head Torque - Norton 961 (Recommended at 1,000 miles - prevent a blown head gasket)
5 - Split Balance Gear Spring - Norton 961 (If your clutch or engine sounds noisy it's likely this)
6 - Transmission Vent - Norton 961 (If you are blowing starter gaskets its probably this)
7 - OIL CHANGE Transmission and Engine - Norton 961 (there is actually a lot to this)
8 - Bulb Change - Norton 961
9 - Cluster removal and re-install - Norton 961 (Latest update 24hr to 12hr clock)
10 - Ignition Coil Replacement - Norton 961
11 - Throttle Control - Norton 961 (there IS a trick to starting these bikes)
12 - Oil in the Airbox - Norton 961 (A good read for those who may not know about this yet)
13 - Starter Solenoid - Norton 961 (At some point in time you will need this)
14 - VALVE CLEARANCE -961 (Check & Adjust)
15 - HANDLE BARS - 961 (Changing to Clip-0ns)
16 - OIL ROUTE - 961 (the flow of the oil thru the engine)
17 - LEVERS - 961(remove and replace)
 
NEW MANUAL AVAILABLE

18 - Fuel Injection - Norton 961

Check your emails. :mrgreen:

PS - ONE07 now has Oil Filters. In USA go to CNW, in Canada email me.
 
Back
Top