'72 Commando transmission shafts dimensions
- Thread starter grandpaul
- Start date
- Joined
- Nov 4, 2007
- Messages
- 1,409
MAINSHAFT PRE COMMANDO AMC GEARBOX, 9 1/4" LONG
www.rgmnorton.co.uk
Have a look on the RGM site they will you all the sizes you want , hope this help..
- Joined
- Sep 4, 2017
- Messages
- 131
a member on the NOC site noticed that too:
"The workship manual gives spec.s for the i.d.s of the various bushes and of the rolling element bearings but not for the corresponding diameters on the shafts..."
www.nortonownersclub.org
In 2008, a member started a thread asking for tolerances of the layshaft and mainshaft he had measured, with two images of the shafts with the dimensions of the location where each gear rotated;
for the mainshaft, "You will notice that two areas that are free from wear (as no bushing/gear runs on these areas) are the original diameter at 0.8100."
and asked, "What is the 'as new' diameter?"
www.accessnorton.com
"The workship manual gives spec.s for the i.d.s of the various bushes and of the rolling element bearings but not for the corresponding diameters on the shafts..."
Gearbox bearing clearances | Norton Owners Club
In 2008, a member started a thread asking for tolerances of the layshaft and mainshaft he had measured, with two images of the shafts with the dimensions of the location where each gear rotated;
for the mainshaft, "You will notice that two areas that are free from wear (as no bushing/gear runs on these areas) are the original diameter at 0.8100."
and asked, "What is the 'as new' diameter?"
Gearbox shaft wear - mainshaft and layshaft
Gearbox shaft wear - mainshaft and layshaft
Evening all. I'm creating a new post for this question. I have a question about what the tolerances (and acceptable worn diameters) are on the mainshaft and layshaft where the various gears rotate. For the layshaft I don't have a lot of concern but would like to know what the 'as new'...
www.accessnorton.com
