1975 Norton Mark 3 throttle and choke cables

I want to build my own cables and have purchased bicycle 1.45mm brake cable and sheathing which is the same size as the original. However, I cannot find the tips of the proper size for the cable ends. (The ones that fit into the carb slide, choke slide, and split connector. I have seen on the forum that others have built their own cables. Can anyone tell me where I can find the end tip? I melted one of the old ones off but it's a pain to get all the old solder out enough to insert the new cable without damage.

Flanders Cables has pretty much everything.
http://www.flanderscables.com/

Thanks!
Probably one of these two? When I get home i'll measure the old ones.

Carb Slide Cable End
Cable end fitting drilled for .064” (1.6mm) wire (610-03100, 03102, 03110, 03112), O.D. .118” (3.2mm), length .137” (3.5mm). Sold each For bag: Order 25
620-24755
.58

Carb Slide Cable End
Cable end fitting drilled for .064” (1.6mm) wire (610-03100, 03102, 03110, 03112), O.D. .126” (3.2mm), length .163” (4.2mm). Sold each For bag: Order 25
620-24762
.48

That's one of the most frustrating things about that model; only Barnett sells complete cable assembly sets (as far as I know). Sure makes life easy, they are affordable and very good quality.

Thanks! I'll check it out.